23
y
Four rows will show as follows:
–
1:
SATA 1 Port
–
2:
SATA 2 Port
–
3:
SATA 3 Port
–
4:
SATA 4 Port( B type model only )
Format
y
You must format when you:
–
install new HDD
–
add another HDD
–
replace HDD
–
move HDD (change installation port)
–
remove HDD
y
Click (
) Add/Remove frame in Format column, and choose ‘OK’ on the dialogue box to start formatting.
y
Following format, DVR will auto-reboot. If there are more than 2 HDDs, please format each of HDDs. DVR will auto-reboot
when all the HDDs are formatted.
y
If the frame changes to ‘---‘ after reboot, it means formatting has been properly done.
S.M.A.R.T
y
Click the frame on S.M.A.R.T column, and temperature and HDD damage will show.
S.M.A.R.T Setup
y
Please click (
) S.M.A.R.T Setup, and the following screen will appear.
y
Check the square box
5
next to Use On. Through S.M.A.R.T function, make alarm message, indicating HDD damage, will
show.
y
Check
5
Beep, it will give the alarm sound, indicating HDD damage, as the SMART setup.
y
Check
5
Blink Message, the alarm message will blink on the OSD, as the SMART setup.
y
If you uncheck Used on, Beep, Blink Message will be unchecked automatically. Only when you check
5
Used on, you can
set Beep, Blink Message function.
y
Click (
) Inspection Time frame to set inspection time.
y
Click Check by frame to select inspection interval.
y
Last Check Time: show the time of the last inspection.
y
Click (
)
▲
,
▼
direction buttons on the right-hand side of Temperature frame to adjust to maximum temperature for the
HDD used in DVR. In general, it is
55
℃
.
y
Click (
)
▲
,
▼
direction buttons on the right-hand side of HDD Damage frame to set the permissible level of HDD damage
(%). HDD is a very crucial element for DVR recording, so set the permissible level within 1% to 2% to assure maximum
safety.
While pressing (+) or (-) button on the rightmost side of Temperature or HDD Damage item, a target value increases or
decreases by 10 units.
y
Choose ‘OK’ to confirm the setting.
CAUTION
EXECUTE REMOVE PROCEDURE EVEN WHEN YOU REMOVE PREVIOUSLY INSTALLED HDD. THE REMOVE PROCEDURE IS
THE SAME AS THE FORMAT PROCEDURE DESCRIBED ABOVE.
Содержание Advanced MPEG-4 DVR
Страница 10: ...9 B Type 4 8 16 Channel Series DVR...