USER MANUAL 16-2090
Rev. 09/2017
Page 15 of 27
6.10 Creating a user profile
•
Tap
the “Log in or create a profile” button.
•
Tap
the “Create a profile” button.
Activating the camera with a blank Fusion Card gives direct access to the following stage.
•
Tap the text field and enter the desired profile name.
•
Tap
the “Return” button.
•
Select a surgical specialty. This will form the basis for the video parameters.
•
Tap
the “Create a profile” button OR scan a blank Fusion Card on the area provided for
this purpose on the lexan housing (the Ackermann logo).
•
A message is displayed for a few seconds indicating that the device supports the
creation of a profile.
•
You can then:
Rename the profile and/or the preset by clicking the “Manage” button.
Delete one (of the) profile preset(s) by tapp
ing “Manage”.
Use the preset created by clicking on it. Log out by tapping
the “Log out” button.
Notes:
If a blank Fusion Card has been scanned at least once (during activation and/or while
saving a created profile), then the profile (and the presets) created will be automatically linked
to this Fusion Card. A padlock icon will be displayed on this profile.
This means that:
The presets locked in this profile cannot be modified without the corresponding Fusion Card.
The names of the presets and the profile name cannot be modified without the corresponding
Fusion Card.
7 Description of the front and back panels
7.1 Mains socket
The camera receives electrical power by means of the mains plug located on the back panel
C2
, which must be connected to the mains power supply by the cable supplied with the
camera. This slot carries a fuse trap as well as a master switch for turning on the device.
The camera uses T1AL - 250V fuses.
When replacing a fuse, the camera must be unplugged and the same type of fuse must be
used. The “T” in “T1A” means “time-delay”. Only use fuses marked UL/CSA.
