Acclaim Lighting Unity SNS2019, Руководство пользователя

Страница: 45 / 56

43
FURTHER INFORMATION
TROUBLESHOOTING
NO LIGHT OUTPUT IS VISIBLE WHEN EXPECTED
•
Check that there is no damage to the power input cord and that power is correctly
applied to the fixture.
•
When 7 channel mode is being used, ensure that the intensity channel (7) is above zero.
•
Use the menu to perform an emitter test - see page 35.
•
Use an RDM tool to perform an emitter test - page 42.
•
Use the menu to check the internal temperature of the fixture - see page 29.
•
If external DMX control is being used, check that the DMX address set within the fixture
matches that being output by the controlling source device.
•
If external DMX control is being used, check the DMX output near to the source to
confirm a valid signal is being originated. When a valid DMX input is attached to Unity, the
user display will show the configured DMX address.
•
If external DMX control is being used, check that the DMX + (hot) and DMX - (cold) lines
have not been crossed.
•
If external control is not used and Solo Behavior is set to Internal Color Mode but no output
is shown, check that a static color or white output has been correctly programmed
into the
Internal Color option (see page 31). Also check whether the Photocell feature
is activated (see page 32) - if it is enabled and the ambient light level is higher than
the programmed sensitivity setting, this will prevent the mixed color/white from being
shown.
•
If Aria wireless DMX control is being used, check that the fixture is set to the same wireless
channel as the transmitter (the wireless channel is independent of the DMX address). Try
changing the transmitter and receiving fixture(s) to different (but equal) wireless channels
to check for clear space in the radio spectrum from interference by other devices, such as
WiFi.
OUTPUT APPEARANCE IS NOT AS EXPECTED
•
Flickering is noticeable when viewed on camera. Adjust the Frequency setting to use a
dimming frequency that does not clash with the camera operation - see page 33.
•
Results do not appear to be correct when selecting temperatures of white in 7 channel
mode. Check that the
Color Calibration is set to on - see page 32.
•
Responses to color mixing/dimming changes do not match other types of fixtures within
the same installation. Try selecting one of the alternative
Gamma
settings built into the
Unity fixture - see page 33.
DIMMING AND/OR CHASE CHANGES ARE JERKY WHEN USING ARIA
•
Check for WiFi sources near to the transmitter or receiver devices. Try changing the
transmitter and receiving fixture(s) to different (but equal) wireless channels to check for
clear space, from interference by other devices, in the radio spectrum - see pages 45
and 46.