F) EVENT
SELECT CH:
Recording parameters of video channel from CH1 to CH16 including
quality, frame rate and so on can be adjusted separately. Before adjusting the
parameter, channel number should be selected first.
QUALITY:
5 levels (VERY LOW, LOW, STANDARD, HIGH, VERY HIGH)
SENSITIVITY:
5 steps (VERY LOW, LOW, STANDARD, HIGH, VERY HIGH)
FRAME RATE:
30, 15, 10, 5, 1FPS for NTSC. 25, 16, 10, 5, 1FPS for PAL
SENSOR TYPE:
N.O (Normal Open) or N.C (Normal Close) can be selected.
EVENT:
motion or alarm for recording can be selected for each channel.
INPUT:
Alarm input from 1 to 16 can be selected for each channel.
PRE-RECORD:
When event is occurred, pre-recording can be saved with recording file
together. Normally, it store 5 seconds in D1 resolution for each channel.
TRIGGER OUT
It defines the selection of trigger output from trigger out1 to 4, when
motion or alarm is detected in some of channels.
Duration:
It defines alarm recording time. 30sec, 1,2,3,4,5, …,10,20,..,60 minutes.
BUZZER
It define beep sound ON/ OFF, when motion is detected.
G) WEEK SCHEDULE
Any day of a week from Monday to Sunday and any time of 24 hour can be reserved
for WEEK SCHEDULE recording.
NOTE:
The recording reservation by event (motion or alarm) is represented as blue color box.
The recording reservation for
Record
in red mark is represented as red color box
< How to setup “WEEK SCHEDULE” >
1. First, select one of recording condition among “None”, ”Record”, “Event”.
2. Time zone for schedule recording can be selected by mouse.
3. After doing WEEK SCHEDULE setting, “UPDATE” should be clicked to update
setting value to remote DVR.
58
