15 Teaching the wireless components
69
Note: The following table gives an overview of which components must have
the channels set to “Impulse” and “Permanent”:
Permanent
Impulse
FU59xx, FU8100, FU8130, FU8140,
FU8150, FU832x, FU8330, FU8370,
FU841x, FU842x, FU8430
FU8300, FU8305, FU8310,
FU8340, FU8350, FU8360,
FU8380, FU8390
These settings do not affect the channel of the external siren if used.
When you are finished, press
ESC/DEL
once. Pressing any other buttons has no
effect on the alarm centre at this point. The bottom LED lights up again permanently.
The main menu is accessed again and LED 3 lights up again.
15.4 Menu 4 – Displaying the signal strength
Press
SELECT
until the fourth LED from the bottom lights up.
Press
SET once
to access menu 4.
The LEDs then display the last received signal strength for every channel. This
happens as follows: First, a channel LED flashes six times and then the signal
strength is displayed as a bar between 0 and 8. The corresponding number of LEDs
(starting from the bottom) light up. The alarm centre then runs automatically through
all of the occupied channels.
This submenu cannot be accessed if no wireless components are trained.
The LEDs show the strength of the received signal. The more LEDs light up (from
bottom to top), the stronger the signal. If only two or fewer LEDs light up, the signal is
not strong enough for reliable operation.
Before doing this, trigger all detectors and operating units once using the
tamper contact or button. Components can also be triggered during the
test, which results in the display of the last received signal strength being
updated.
The display of the last received signal strength on the channels can be
reset manually by pressing SW4
(B)
. Only newly received signals are now
displayed.
When you are finished, press
ESC/DEL
once to access the main menu again.
When you are finished, press
ESC/DEL
once. Pressing any other buttons has no
effect on the alarm centre at this point. The bottom LED lights up again permanently.
The main menu is accessed again and LED 4 lights up again.
