![background image](http://html1.mh-extra.com/html/abm/superbike/superbike_installation-and-safety-information_3443902016.webp)
Installation manual Superbike
™
for Kawasaki ZX-10 R model 2016-
• Revision: 00 • 30/01/2020 •
© ABM Fahrzeugtechnik GmbH
Page 16 of 19
Connect the new to the old clutch cable
with a cable tie.
Pull the old cable through the fairing, thus
pulling in the new cable at the same time.
Clip in the clutch cable again. Attach and
adjust it with the holder.
The final assembly of the operating
elements requires the drilling of holes for
the centring pins. To do this, align the
operating elements and mark the positions
for the centring pins (push onto the pins
using grease). Now, centre-punch the
marked position and drill a hole (diameter
and depth are based on the centring pin).
Before the final fixing of the handlebar and
the armatures, make sure that the
handlebar does not come into contact with
any other parts (e.g. fairing or tank), even
in maximum steering angle. Clip the clutch
cable into the armature.
Then tighten the screws of the clamps.
Tightening torque 24 NM
Assemble the cover caps.