Ablerex Buck 1000W, Руководство пользователя

Страница: 16 / 24

16
Step1: Step1: Enter into Pulse Charge Setting. If it shows “ON” it means the charger is
able to be in Pulse Charge; on the contrary, it means the charger is not able to be in
Pulse Charge if it shows “OFF”.
Step2: You may select “ON” or “OFF” by pressing key or key, then press
key to save till “SAVE” shown on the screen. When “SAVE” disappears
on the screen, it means your setting is done successfully.
Step3: You may escape from this setting by pressing key.
2.1.7 Parallel Address Setting
When there are several chargers in parallel, you may proceed the setting as below:
Step1: Enter to Parallel Address Setting, then the charger will show the address of the
charger in parallel.
Step2: To select other desired parallel address, you may press key or key
to choose the figure you prefer. The figure with blinking means the current
place you are. To change the figure at left-hand side, please press key,
on the contrary, you may press key to change the right-hand side.
Step3: The selectable range of the parallel address is 1~254. When the desired parallel
address is selected, please press key to save till “SAVE” shown on the
screen. When “SAVE” disappears on the screen, it means your setting is done
successfully.
Step4: You may escape from this setting by pressing key
2.1.8 Total Input Power(KWH)Setting:
To set the initial value of the total input power(KWH), user may set the total input power
to “zero” or “certain value”. The setting method is as below:
Step1: Enter into total input power setting, it shows ”0000”
。
S
tep2: If you would like to set other initial value, you may use key or
key to select desired value. When the figure selected is blinking, it means the
figure that you may change. “K” at the right-hand side means “1000”times, so
if the screen shows 123K means 123000 KWH. If you would like to change the