User manual Version 1.5
SW5001 Wireless Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan
- 4 -
3. Software
Setup
Now the SW5001 hardware is installed and power is on, network IP configuration will be set in this
section.
3.1. Default Settings
The SW5001 has two IP addresses one for Ethernet interface and another one for wireless network
interface. These default settings are shown from under information
Default IP addresses
Interface
Device IP
Subnet mask
Gateway IP
LAN port
10.0.0.50.100 255.255.0.0 10.0.0.254
WLAN Port
192.168.1.1
255.255.255.0 192.168.1.254
The other default settings of SW5001 are shown in the following table
Property
Default Value
Ethernet Port
IP Address
10.0.50.100
Gateway
10.0.0.254
Subnet Mask
255.255.0.0
WLAN Port
IP Address
192.168.1.100
Gateway
192.168.1.254
Subnet Mask
255.255.255.0
Security
User Name
Admin
Password
Null
(Leave it blank)
Serial
COM
9600/None/ 8/1,No flow control, buffer disabled, packet delimiter timer
1ms
Link Mode
TCP Server, Listen port 4660,No Filter, Virtual COM disabled
SNMP
SysName of SNMP
Name
SysLocation of SNMP
Location
SysContact of SNMP
Contact
Table 1. Default settings of the SW5001 device
NOTE: Press reset button for 5 seconds then release the button to restart SW5001 to the default
settings.
Waring: Please avoid setting LAN and WLAN IP address in the same subnet. That may cause
unexpected networking problem.
