ABL Wallbox eMH2, Руководство по установке

Страница: 39 / 60

Configuring the Wallbox eMH2 –
Completing the set-up |
39
Completing the set-up
After setting up communication with the backend, the group installation is complete.
1
Close the
Charge Point Administration
applica-
tion via the browser window.
2
Disconnect the computer from the wallbox by un-
plugging the RJ45 data cable from the SBC of the
Controller charging station (and the computer).
3
Replace the electronic components cover onto the
housing base and fix it into place with its proper
screw.
4
Hook the housing cover onto the upper edge of the
housing base and lock it using the housing cover
key.
Manual RFID card administration
For all other Wallboxes eMH2 (except product bundles), the
E017869
package of 5 ID tag cards is available, which
can be configured for use as a teach-in card (1 pc) and RFID user cards (4 pcs) using the
ABL Configuration Soft-
ware
.
Using the teach-in card, ID tag cards can be registered on the user list of the wallbox, and then used to authorise
charging procedures. In addition, the user list of the wallbox can be reset, and all previously registered ID tag cards
can be deleted using the teach-in card.
NOTE
Administering RFID cards via the ABL Configuration Software
Before use, you must set up one of the cards from the E017869 as a teach-in card using the ABL Configuration
Software
.
ƒ
Setting up the ID tag cards from the accessory set E017869 is carried out in the Individual configuration
> Advanced configuration > Access control via RFID
tab of the
ABL Configuration Software
, and is
described in the accompanying manual.
Proceed as follows to register an ID tag card manually at the wallbox:
1
Ensure that the wallbox is switched on and ready
for operation.
y
When the wallbox is ready for operation, the
green LED pulsates.