ABL eMH1 WALLBOX, Инструкция по эксплуатации

Страница: 15 / 34

inStallatiOn and pOwer Supply cOnnectiOn
11
CAUTION!
Check the measurements on the drilling template with a calibrated
measuring tape BEFORE you mark the drill holes using the tem-
plate and then drill them.
Drilling the mounting holes using the drilling template
Proceed as follows to drill the holes using the drilling template:
1. Place the drilling template vertically on the mounting surface, using a spirit level if
necessary.
2. Mark the drill holes using the template.
3. Drill the marked mounting holes (Ø 8 mm) and check the positions of the holes us-
ing the drilling template.
4. Insert the wall plugs for the mounting screws.
Preparing the charging station
Proceed as follows to prepare the charging station for installation:
1. Open the cover shield of the EVSE 5X2 using the key supplied.
2. Loosen the four screws connecting the front part of the housing with the rear part:
Keep the screws in a safe place as you will need them again to complete installa-
tion.
3. Pull off the front part of the housing.
4. Remove the plastic tongue intended for the power supply in the lower section of
the rear part of the housing using a suitable pair of pliers or a cutter.
5. Use the cutter to cut an opening to suit the power supply cable into the rubber
seal of the rear part of the housing. If necessary, remove the rubber seal for this
purpose and place it back into the rear part of the housing afterwards.
Mechanical installation of the charging station
1. Fix one screw (5 x 60 mm, screw head Ø 8 mm) in the top drill hole and hang the
upper mounting point of the charging station on it.
2. Fix the two lower mounting points using the other two screws (5 x 60 mm, screw
head Ø 8 mm).
3. Tighten the two lower screws so that the rear part of the housing is held in place
without being deformed by the tension applied to the mounting points.
Electrical installation of your charging station
The electrical connection of the EVSE 5X2 to your domestic power supply and taking