ABL eMH1 WALLBOX, Инструкция по эксплуатации

Страница: 19 / 34

taking intO OperatiOn and charging prOcedure
15
Safety information for taking the charging station into operation
Before you take your EVSE 5X2 charging station into operation, you must observe the
following safety notices:
• Ensure that the EVSE 5X2 is connected to the domestic power supply according to
the instructions in this manual and the separately available service guide.
• Ensure that the EVSE 5X2 is separately protected in your domestic power distribu-
tion box by a suitable miniature circuit breaker (MCB, C characteristic).
• Ensure that the integrated or onsite (depending on model variant) FI residual current
circuit breaker (RCCB) is switched on.
• Ensure that the EVSE 5X2 has been installed according to the instructions in this
manual: Check especially that there is free access to the charging station, that it is
not exposed to direct sunlight or rain and that the electric vehicle can be connected
without any strain or other encumbrance on the charging cable.
• Ensure that the housing cover shield of the EVSE 5X2 is always locked during normal
operation.
• Ensure that the separately available charging cable is not twisted and check that
cable, connector and housing do not show any observable damage.
Normal operation
On the right side of the housing, the EVSE 5X2 is fitted with a charging socket accord-
ing to IEC 62196-2, Type 2 with electromechanical locking function. To protect against
faulty charging as well as possible electric shock, the charging plug is locked in the
charging socket as soon as the charging cable is properly connected to both charg-
ing station and electric vehicle. The lock is released only after the charging process is
complete, when a voltage is no longer applied to the current-carrying contacts of the
socket.
A charging cable (available separately) is required for the charging process itself. The
models available from ABL are listed on page 7 and you can obtain further informa-
tion on the ABL website at
www.abl.de
as well as from your local distributor.
The separately available charging cable for the EVSE 5X2 is 4 approx. meters long to
offer a flexible connection between charging station and vehicle. In practice it is advis-
able to remove the charging cable after each charging process. Should you wish to
store the cable near the charging station, it is recommended that you install the sepa-
rately available wall storage bracket WHEMH10 (see page 7) as well. Now you can
roll the cable up tightly and hang it on the cable hanger of the WHEMH10: This way it
is always close at hand.