![background image](http://html1.mh-extra.com/html/abicor-binzel/pp-plus-240-d/pp-plus-240-d_operating-instructions-manual_451648033.webp)
BAL.0140 • 2018-10-15
EN - 15
PP Plus 36D/240D/401D
5 Operation
4.11 2-cycle function of the trigger
1
Press the trigger on the handle and keep it pressed = welding is started.
2
Release the trigger = welding is stopped.
5 Operation
1
Open the shielding gas cylinder.
2
Switch on the power supply.
3
Set the welding parameters.
4
Start welding.
6 Putting out of operation
1
Stop welding.
2
Wait until the shielding gas flow has subsided and then switch off the power supply.
3
Close the valve of the shielding gas cylinder.
NOTICE
• Hose assemblies containing PVC hoses will start leaking if the return coolant temperature
is exceeded. Make sure not to exceed a return coolant temperature of 60°C.
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the
welding system are strictly observed before putting out of operation begins.
• Liquid-cooled cable assemblies may start leaking if overheated. This is why the cooling
unit should continue running for approx. 5 min. after welding.