![background image](http://html1.mh-extra.com/html/abicor-binzel/pp-plus-240-d/pp-plus-240-d_operating-instructions-manual_451648026.webp)
EN - 8
BAL.0140 • 2018-10-15
4 Putting into operation
PP Plus 36D/240D/401D
4.3 Mounting the wire guide
4.3.1 Liner
To be used for steel wires.
1
Lay down the cable assembly
straight and unscrew nut
from central connector
.
2
Slide the liner
through the wire conduit
until a noticeable resistance is felt in the inlet
.
3
Determine excess length x and pull out the liner
again.
4
Shorten the liner
by the dimension x.
5
Debur the cutting point and sharpen the spiral beginning to an angle of 40°.
6
Insert the liner cut to length
.
NOTICE
• Only use gas-tight, plastic-insulated wire guides to ensure a secure shielding gas cover
and a defined current contact.
• Bare liners give rise to a loss of shielding gas.
NOTICE
• New and unused liners must be abridged to the actual length of the cable assembly.
• To install the wire guide with a little preload, excess length is required.
1
Torch neck
2
Inlet nipple
3
Wire conduit
4
Central connector
5
Multiple wrench
6
Nut
7
Holding nipple
8
Liner
9
Cable assembly
Fig. 3
Liner
40°
x
4 – 5 mm
1
2
3
4
5
6
7
8
9