Abicor Binzel ADF735S, Оригинальная инструкция по эксплуатации

Страница: 12 / 72

EN-12
• ADJUSTING THE DISTANCE BETWEEN THE HELMET AND THE FACE
Step 1: Undo the block nut (S ee “T” in fig. 5) to adjust the distance between the helmet
and your face in the down position.
Step 2: Loosen the block nut on either side of the helmet and slide it nearer or further
from your face (S ee adjustment “Z” in fig. 5). It is important that your eyes are each the
same distance from the lens. Otherwise the darkening effect may appear uneven.
Step 3: Re-tighten the block nut when adjustment is complete.
• ADJUSTING VIEW ANGLE POSITION
TILT: Tilt adjustment is located on right side of helmet. Loosen the right headgear tension
knob and push the top end of the adjustment lever outward until the lever’s Stop Tab
clears the notches. Then rotate the lever forward or back to the desired tilt position. The
Stop will automatically engage again when released locking the helmet into position
(See fi g. 6).
• You are now ready to use the helmet. The shading may be adjusted during use
by re-setting the potentiometer control.
SHADE GUIDE TABLE (NO. 1)
Welding Process
ARC CURRENT (Amperes)
0.5 2.5 10 20 40 80 125 175 225 275 350 450
1 5 15 30 60 100 150 200 250 300 400 500
SMAW 9 10 11 12 13 14
MIG (heavy) 10 11 12 13 14
MIG (light) 10 11 12 13 14 15
TIG, GTAW 9 10 11 12 13 14
MAG/CO2 10 11 12 13 14 15
SAW 10 11 12 13 14 15
PAC 11 12 13
PAW 8 9 10 11 12 13 14 15
NOTE:
SMAW – Shielded Metal Arc Welding
MIG (heavy) – MIG on Heavy Metals
PAW – Plasma Arc Welding
SAW – Shielded Semi-Automatic Arc Welding
TIG, GTAW – Gas Tungsten Arc Welding
MIG (hight) – MIG on Light Alloys
PAC – Plasma Arc Cutting
MAG/CO2 – Metal Active Gas
MAINTENANCE
• REPLACING FRONT COVER LENS
Replace the front cover lens if it is damaged. Remove ADF holder assembly per fig. 7.
Remove front cover lens from helmet assembly. Carefully remove gasket from cover lens.
Install new cover lens into gasket and assemble to helmet shell. Make sure to assemble
cover lens and gasket into helmet shell the same way as it was removed.
• REPLACING INSIDE COVER LENS
Replace the inside cover lens if it is damaged. Place your fingernail in recess below
cartridge view window and flex lens upwards until it releases from edges of cartridge view
window.
• CHANGE THE AUTO DARKENING FILTER
Remove ADF holder assembly from helmet shell. See fig. 7 for removal. Flex top end of
the ADF holder to allow for ADF cartridge to be removed from frame. Install new ADF