Abicor Binzel ADF735S, Оригинальная инструкция по эксплуатации, Страница: 10 / 72

EN-10
• Auto-Darkening filter does not darken or flickers
①
Front cover lens is soiled or damaged (Change the cover lens).
②
Sensors are soiled (Clean the sensors surface).
③
Welding current is too low (Adjust the sensitivity level to higher).
④
Check battery and verify they are in good condition and installed properly. Also, check
battery surfaces and contacts and clean if necessary. Please referring to the “
BATTERY
INSTALLATION ” on page 10.
• Slow response
Operating temperature is too low (Do not use at temperatures below − 10°C or 14°F).
• Poor vision
①
Front / inside cover lens and / or the filter is soiled (Change lens).
②
There is insufficient ambient light.
③
Shade number is incorrectly set (Reset the shade number).
④
Check if removing the film on the front cover lens.
• Welding helmet slips
Headgear is not properly adjusted (Readjust the headgear).
WARNING
The user must stop using the auto-darkening welding helmet immediately if the
above-mentioned problems cannot be corrected. Contact the dealer.
INSTRUCTIONS FOR USE
WARNING! Before using the helmet for welding, ensure that you have read and understood the safety instructions.
• BATTERY INSTALLATION
Install the battery into helmet properly, according
to positive and negative terminal marking on
battery jar (See fi g. 1).
• POWER
This ADF cartridge is powered by solar cell and
1 CR2450 lithium battery. When the indicator
located on the lens starts to come to red (See
fig. 2), it is a warning for the battery to be
replaced.
Please notice the anode
and cathode while
mounting the battery.
fig. 1
• TEST
Press and hold test to
preview shade selection
before welding (S ee fig. 2).
When released then viewing
window will automatically
return to the light state
(3.5 Shade).
fig. 2
• SELECTING SHADE LEVEL
Select the shade level you require according to the welding process you will use by
referring to the “Shade Guide Table” below for settings. Turn the shade control knob to
the shade number required.
Green
Red
GRIND
LOW
BATTERY
LOW
BATTERY
GRIND