Abicor Binzel ABIDRIVE CW, Руководство по эксплуатации

Страница: 29 / 68

TIG cold wire feeder 7 Putting out of operation
EN - 13
6.1 Operating elements
ABIDRIVE CW

Fig. 4 Overview of connections and operating elements on page EN-9
6.2 Power supply operating elements

Fig. 4 Overview of connections and operating elements on page EN-9
6.3 Putting into operation

Fig. 4 Overview of connections and operating elements on page EN-9
1
Switch on the
(17)
power switch.
2 Open the valve of the shielding gas cylinder.
7 Putting out of operation

Fig. 4 Overview of connections and operating elements on page EN-9
1
Switch off the
(17)
power switch.
2
Close the valve of the shielding gas cylinder.
Symbol Designation
Wire feeder dial
(6)
Wire feed rate can be set continuously.
Program selection switch
(8)
The following programs can be set: four-stroke, two-stroke, four-stroke interval and two-
stroke interval
Timer / Pause dial (10)
The pause time can be set independently of the wire feeding time.
Timer / Feed dial
(7)
The delivery time for the welding wire can be regulated.
Display
(9)
The preset wire feed rate is displayed. Changes on the dial
(6)
are applied the next time
welding is started.
NOTICE
• The dials
(7)
and
(10)
only work in the interval mode.
• The dial scales serve exclusively for orientation with respect to the set values.
Symbol Designation
Power switch
(17)
Switching state ON and OFF.
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
strictly observed before putting out of operation begins.