Starting Your Sensor
Step
Action
1
Press the Home Button to turn on the Reader .
2
Touch
Start New Sensor
.
3
Hold the Reader within 4 cm (1 .5 inches) of the
Sensor to scan it . This starts your Sensor . If sounds
are turned on, the Reader beeps when the Sensor
has been successfully activated . The Sensor can
be used to check your glucose after 60 minutes .
Note:
If the Sensor is not successfully scanned
within 15 seconds, the Reader displays a prompt
to scan the Sensor again . Touch
OK
to return to
the Home Screen and touch
Start New Sensor
to scan your Sensor .
Start New
Sensor
Review
History
No Active Sensor
22:23
minutes
New Sensor
Starting Up
60
Sensor can be used in:
OK
Step
Action
8
Gently pull the Sensor Applicator away from your
body . The Sensor should now be attached to
your skin .
Note:
Applying the Sensor may cause bruising
or bleeding . If there is bleeding that does not
stop, remove the Sensor, and apply a new one at
a different site .
9
Make sure the Sensor is secure after application .
Put the cap back on the Sensor Applicator .
Discard the used Sensor Pack and Sensor
Applicator . See
Disposal
section .
Sensor
23
24
ART41600-101_rev-A_manual.indd 23-24
ART41600-101_rev-A_manual.indd 23-24
10/7/20 2:55 PM
10/7/20 2:55 PM