ABB XSeries G4 6200, Руководство пользователя, Страница: 46 / 168

Page 2
–4
2104349 rev. AD
5)
Attach the pole mount bracket to the top of the 2” pipe with the U-bolts. Use
the provided hex nuts, flat washers and spring lock washers to tighten the
pole mount bracket to the 2” pipe.
Position the mounting bracket high enough on the pipe to
allow slope from the externally mounted manifold to the tap
valves.
6) Remove the lower two hex screws, hex nuts, flat washers and spring lock
washers from the transducer’s attached mounting brackets.
7)
With the associated hardware removed, align the transducer’s bottom
mounting holes with those on the pole mount bracket.
8) Upon alignment, replace the hex screws, hex nuts, flat washers and spring
lock washers through their respective mounting holes on the mounting
brackets and into the pole mount bracket. Upon completion, tighten (see
Figure 2
–2).
Figure 2
–2 Type B Installation Configuration
It should be noted that if this is the type of installation
configuration that the user has received from the factory,
there may be additional parts within the provided mounting
kit assembly that are not used.
2.2.3 Type C
2.2.3.1
Materials supplied
- G4 EX mounting kit assembly and associated hardware
2.2.3.2
Materials not supplied
-
One 2” x 40” pipe
- Standard 3 or 5 valve manifold