ABB VUBB, Руководство по установке и пусконаладке

Страница: 67 / 80

Installation and commissioning guide
1ZSC000562-AAK EN, REV. 2, 2019-07-03
67
9. Make sure that the center of the notch (4) in the
cam disc stops within ±2 mm of the center of the
roller.
If it does not stop at the center of the notch (4),
then refer to the maintenance guide
Motor-drive
mechanisms, types BUE and BUL2
1ZSC000498-ABH.
NOTE!
The brake assembly is at position (3).
G004433
10. Do a check of the electrical end-stops:
1. Operate the tap-changer electrically to one end-stop.
It should not be possible to electrically operate the tap-changer against the mechanical end-stop.
2. Operate the tap-changer electrically to the other end-stop.
It should not be possible to electrically operate the tap-changer against the mechanical end-stop.
11. Do a check of the mechanical end-stops:
1. Operate the tap-changer manually to one end-stop.
The tap-changer should stop at the mechanical end-stop.
2. Operate the tap-changer manually to the other end-stop.
The tap-changer should stop at the mechanical end-stop.
NOTE!
After a couple of turns on the hand crank, the tap-changer should reach the mechanical
end-stop.
12. Make sure that all tests have been completed, and that the end-stops are functional.
CAUTION!
Do not energize the transformer with an end-stop that is not functional. Catastrophic failure
of the transformer can occur.
13. The installation of the tap-changer is complete and the transformer is ready for testing.
End of instruction
8.3 Testing of the protection devices
Overview
Do funcional tests of the protection devices, please refer to Accessories and protection devices for on-load
tap-changers, 1ZSC000562-AAD.
Refer to the packing list for the configuration of protection devices.