ABB MicroFlex e150, Руководство пользователя

Страница: 88 / 180

88 Installation checklist

Safe Torque Off (STO) connections
The STO inputs are an intrinsic part of a safe drive installation.
The acceptance test of the safety function must be carried out by an authorized
person with expertise and knowledge of the safety function. The test must be
documented and signed by the authorized person.
The MicroFlex e150 will operate only when the STO inputs are powered.
See
Appendix: Safe Torque Off (STO)
on page
173
.
Appropriate supply fuses and disconnector have been installed.
The motor cable has been connected to appropriate terminals, the phase order is
correct, and the terminals have been tightened (pull conductors to check).
The brake resistor cable (if present) has been connected to appropriate terminals, and
the terminals have been tightened (pull conductors to check).
The motor cable (and brake resistor cable, if present) has been routed away from other
cables.
No power factor compensation capacitors have been connected to the motor cable.
All low voltage control cables have been correctly connected.
If a drive bypass connection will be used (for induction motors): The direct-on-line
contactor of the motor and the drive output contactor are either mechanically or
electrically interlocked (cannot be closed simultaneously).
There are no foreign objects or dust inside the drive.
Drive and motor connection box covers are in place.
Verify that all wiring conforms to applicable codes.
The motor and the driven equipment are ready for start-up.
Disconnect the load from the motor until instructed to apply a load. If this is not
possible, disconnect the motor wires at connector X1.
Check no physical damage is present.
Check all instruments have been properly calibrated.
Check that …