12
LME620-AI / PME120-AI / EAN823 / EBN853 / EBN861
ELECTRONIC UNIT | OI/PME/LME/EAN823/EBN853/EBN861-EN REV. E
4
Transport and storage
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
Transporting the device
Safety instructions
DANGER
Danger to life due to falling or toppling loads.
Risk of death or serious injury due to the device falling down
or toppling over!
• Standing under suspended loads is prohibited.
• Do not detach the hoisting equipment until installation is
complete.
• Only use the dedicated load pick-up devices (eyebolts) for
suspending the components.
Consider the following items during transport:
• Pay attention to the device weight details.
• Do not expose the device to humidity during transport.
Pack the device accordingly.
• Pay attention to the permissible transportation
temperatures for the device.
Returning devices
For the return of devices, follow the instructions in
Returning
devices
on page 38.
Storing the device
The electronic units LME620-AI / PME120-AI / EAN823 / EBN853
/ EBN861 comply with IP rating IP 20. The electronic units should
be stored in accordance with this IP rating. Condensation is not
permitted.
The permissible storage temperatures as well as the ambient
conditions (humidity) should be complied with (see
Device
designs
on page 8).
For longer storage periods, we recommend packing the units in
foil with a dessicant added.
The dessicant must be checked for regularly for effectivity.
5
Installation
Safety instructions
DANGER
Danger to life due to falling or toppling loads.
Risk of death or serious injury due to the device falling down
or toppling over!
• Standing under suspended loads is prohibited.
• Do not detach the hoisting equipment until installation is
complete.
• Only use the dedicated load pick-up devices (eyebolts) for
suspending the components.
Please observe the following safety instructions
• Only qualified specialists may mount and adjust the control
actuator, and make the electrical connection.
• When working on the actuator or the electronics always
observe the locally valid accident prevention regulations and
the regulations concerning the construction of technical
installations.
• Switch off the supply voltage and take precautions to
prevent unintentional switch-on.
Mounting
NOTICE
Damage to components!
Damage to components caused by ingress of foreign bodies
or humidity.
• Keep all housing covers and terminal compartments
closed during installation to prevent the ingress of foreign
bodies such as drilling shavings, liquids or dust.
When installing the electronic unit, observe the following points:
• You must be able to activate the power supply of the
electronic unit on-site.
• All signal cables and the motor cable between the
actuator and electronic unit must be shielded.
• The cable shield must be placed on both housings when
connecting the electronic unit and the actuator.
• The maximum vibration load must be observed during
installation, see
Device designs
on page 8.
• When mounting the electronic unit in work and traffic
areas that may be accessed by unauthorized persons, the
operator is required to take suited protective measures.
