ABB FPTC-02, Руководство пользователя

Страница: 68 / 96

Action
Settings with voltage connected
Make sure that you have activated the FPTC module in the correct slot
(parameter
35.30 ).
Make sure that you have set all the necessary parameters for the safety
function. See chapter
Parameter settings .
Acceptance test procedure
Make sure that you can run and stop the motor freely during the test.
Start the drive and make sure that the motor is running.
Cause an overtemperature situation: Increase the resistance in the
XFLT input to more than 3.6 kohm (for example, open the circuit by
disconnecting the wires).
Make sure that the correct indications are activated: The SMT fault and
other indications depending on the parameter settings and if an FSO
module is installed.
Make sure that the STO is activated and that the motor coasts to a stop.
Make sure that you cannot start the drive before you have reset the
drive.
Reset the drive. Make sure you cannot reset and restart the drive before
the input resistance in the XFLT input decreases to less than 1.6 kohm.
Restart the drive and the motor. Make sure that they operate normally.
Cause a short-circuit situation: Decrease the resistance in the XFLT
input to less than 50 ohm.
Make sure that the correct indications are activated: The SMT fault and
other indications depending on the parameter settings and if an FSO
module is installed.
Make sure that the STO is activated and that the motor coasts to a stop.
Make sure that you cannot start the drive before you have reset the
drive.
Reset the drive. Make sure that you cannot reset and restart the drive
before the input resistance in the XFLT input increases to more than
50 ohm.
68 Start-up and acceptance test
31