ABB ACS580-01 drives, Руководство по оборудованию

Страница: 110 / 226

110 Electrical installation
Installing option modules
Note: If you will install the FPBA
-
01 module, see section FPBA-01 PROFIBUS DP
adapter module connectors on page 63 for suitable connector types.

Mechanical installation of option modules
See section Overview of power and control connections page 31 for the available
slots for each module. Install the option modules as follows:
WARNING! Obey the instructions in chapter Safety instructions on page 13 . If
you ignore them, injury or death, or damage to the equipment can occur.
Note: Slot 2 in frames R0…R4 is at U
DC
potential. You must disconnect power
supplies before installing or removing an I/O extension module.
Stop the drive and do the steps in section Precautions before electrical work on page
16 before you start the work.
1. Remove the front cover(s) if not already removed. See page 81 (R0…R4), page
53 (R5) or page 56 (R6…R9).
The figures for frames R0…R4 (page 111 ) and R6…R9 (page 112 ) show an example
of installing option modules.
Option slot 3 (embedded fieldbus adapter modules)
2. The drive is delivered with the standard embedded fieldbus adapter module
CEIA-01 installed.
If you have ordered another option module, remove the CEIA
-
01 module by
carefully bending the retaining clips to the sides while pulling the module outward,
and put the other module carefully into its position.
Note: Frames R0…R4: The module in option slot 3 is under the module in option slot
1. If you have to change the module in option slot 3, remove first the any module in
option slot 1, if present.
Option slot 2 (I/O extension modules)
3. Put the module carefully into its position on the control board.
4. Tighten the mounting screw.
5. Tighten the grounding screw (CHASSIS). Note: The screw grounds the module. It
is necessary for fulfilling the EMC requirements and for proper operation of the
module.
Note: Frames R0…R2: The module in option slot 2 covers the power terminals. Do
not install a module in option slot 2 before you have installed the power cables.