USE & PERFORMANCE OF YOUR ABJET
®
TENDER
AFTER USE
After use
Remove the boat from the water every day to prevent growth
of algae or other marine organisms.
NOTICE
Failure to perform proper care such as: boat rinsing,
exhaust system flushing and anti- corrosion treatment
among others, will result in damage to the boat and its
components.
WARNING
When operating the engine while the boat is out of water, the
heat exchanger in the ride plate may become very hot. Avoid
any contact with ride plate as burns may occur.
•
The boat has two flushing points (Except ABJET 285): one on
the pump support and the other one on the deck. To flush the
engine, c
onnect a garden hose to the connector
of any of the
two flushing points.
Do not open water tap at this time.
The exhaust system should be flushed daily when boat is
used in salt or foul water.
Anticorrosion Treatment
To prevent corrosion, spray an appropriate corrosion
inhibitor (resistant to salt water) or equivalent anti-corrosion
agent over all metallic components on the engine
compartment.
Apply Dielectric Grease, (resistant to salt water) on battery
posts and cable connectors.
Exhaust System Flushing
Flushing the exhaust system with fresh water is essential to
neutralize corroding effects of salt or other chemical products
present in water. It will help to remove sand, salt, shells or
other particles in water jackets and/or hoses.
Proceed as follows:
1
Flushing
Point
•
To flush, start engine and then immediately, open the water
tap.
NOTICE
Never flush a hot engine. Always start the engine before
opening the water tap. Open water tap immediately after
engine is started to prevent overheating.
27
Содержание ABJET 285
Страница 1: ...Owner s manual ...
Страница 19: ...GENERAL DESCRIPTION STANDARD EQUIPMENT ...
