AB Inflatables ABJET 285, Руководство пользователя

Страница: 32 / 47

USE & PERFORMANCE OF YOUR ABJET
®
TENDER
AFTER USE / TOWING YOUR INFLATABLE
Run the engine about 20 seconds at a fast idle between 4000-
5000 rpm.
NOTICE
Never run engine without supplying water to the exhaust
system when boat is out of water.
Ensure water flows out of jet pump while flushing. Otherwise,
refer to an authorized ABJET® Service Center for servicing.
NOTICE
Never run the engine out of the water longer than 2 minutes.
Drive line seal has no cooling when boat is out of water.
Close the water tap, then stop the engine.
NOTICE
Remove quick connect adapter after flushing operation (if used).
For further information, please refer to the BRP’s Operators
Manual included in the Owner’s package.
Towing your boat
NOTICE
Special precautions MUST be taken when towing a BRP
Rotax powered boat in the water to prevent the exhaust
system and engine from filling with water.
NOTICE
You should only tow your tender for short distances at a
recommended speed.
There are a few different ways to tow your inflatable boat. The
following descriptions are AB recommendations . All RIBs
should be towed by the bow eye (U-bolt). The performance of
the boat will vary depending on the speed, sea conditions, wind
and the distance between boats. Leave at least two (2) boat
lengths between the boats for adequate movement. The exact
distance depends upon the vessel being towed and should be
determined by experience. Adjust the length of the bow line to
match the wave action. Attach a second line to the towed
boat’s bow eye (U-bolt) and tie it separately to the main vessel.
This provides additional safety if main line fails .
Maximum recommended towing speed is 24 km/h (15MPH).
WARNING
The shut off valve MUST be closed for this procedure; otherwise,
water can get into the engine sleeve and may generate a
catastrophic damage. Failure to do so will damage
28