AAVIX AGT1424S, Руководство пользователя

Страница: 17 / 33

17
Auger control test
NOTE: Perform the following
test before operating your
product for the first time and the start of
each winter season.
When the auger control lever is released
and in the disengaged upper position, the
auger wire should have very little slack. It
should not be tight.
1. Stand behind the product.
2. Engage the auger and allow the auger
to remain engaged for approx. 10
seconds.
3. Release the auger control lever.
4. Repeat the step 2 and 3 for several
times.
5. Make sure that the auger has
completely stopped when releasing the
lever.
Drive control lever
Squeeze the lever to engage the wheel
drive. Release it to stop.
Gear lever
The gear lever is located in the right side
and is used to determine both ground
speed and direction. It can be moved to
any of 6 positions (4 forward speeds, 2
reverse speeds).
WARNING! Always release
the drive and auger control
lever and wait until rotating
parts come to a full stop before
changing the gear!
When starting the product, always use a
lower gear position first!
Forward speeds
Press the gear lever downwards and set
it to one of the four positions to the left
and set it upward to operate the product
in forward mode (1 = slow, 4 = fast).
Choose a slower speed for heavier snow
and faster speed for light snow and
transporting the product.
NOTE: We recommend using
a slower speed until you are
familiar with the operation of the
product.
Reverse speeds
Press the gear lever downwards and set
it to one of the two positions to the right
to operate the product in reverse mode
(R1 = slow, R2 = fast).
WARNING! Be extremely
careful when moving
backwards! Pay attention
to your steps! Ensure that you do not
step on obstacles!