Aastra OpenCom 100, Руководство по монтажу и пусконаладке

Страница: 85 / 244

Configuration Configuring the OpenCom 100
83
Connection via ISDN
The connection for remote configuration is established using an internal RAS
access. The RAS access is activated when a data call from one of the registered
phone numbers is registered. During remote configuration, the OpenCom 100 is
blocked for RAS access by any further users.
If no RAS access has been configured in the OpenCom 100 Configurator, you can
use a code procedure to release the internal RAS access for remote configuration,
and then block it again. The manual activation is automatically cancelled 30
minutes after the last configuration activity. You can add additional phone
numbers for remote configuration on the configurator’s
Telephony : Extended :
Remote service menu page. Activate the ISDN option for the desired phone
numbers.
Connection via Internet
The connection for remote configuration is established indirectly over the
Internet. The connection session starts with a voice call from one of the registered
phone numbers. During the call, connection parameters (IP address, keys) will be
sent using a DTMF sequence. Afterwards, the OpenCom 100 communications
system establishes a secured SSH connection to an Internet server. The existing
SSH connection allows to reverse-connect to the OpenCom 100 communications
system’s configurator. For this type of connection, the OpenCom 100 communica-
tions system utilizes your Internet account. Establishing an SSH connection via this
Internet account must be allowed for this purpose.
The manual activation of the remote configuration activates the DTMF evaluation
for the next voice call. You can add additional phone numbers for remote configu-
ration on the configurator’s Telephony: Extended: Remote service menu page.
Activate the IP option for the desired phone numbers.
Note: You also need to activate the desired type of connec-
tion directly on the Telephony : Extended : Remote service .
Manual Activation
The following code number procedures activate or de-activate the remote config-
uration access. These code digits can be entered on any standard terminal or
system telephone.
Remote Configuration On (Log-on with Administrator Password)
H * 1 9 * Z
(system PIN)
#