AAON H3 Series, Установка, эксплуатация и обслуживание

Страница: 10 / 80

10
1. Startup and service must be performed by
a Factory Trained Service Technician.
2.
The unit is for indoor use only. See
General Information section for more unit
information.
3.
The supply and return air ducts must be
derived from the same space. It is
recommended ducts be provided with
access panels to allow inspection for duct
tightness. When a down flow duct is used
with electric heat, the exhaust duct must
be an L shaped duct.
4. These units must not be used for heating
or cooling at any time during any phase
of construction. Very low return air
temperatures,
harmful vapors, and
misplacement of the filters will damage
the unit and its efficiency
5.
Every unit has a unique equipment
nameplate with electrical, operational,
and unit clearance specifications. Always
refer to the unit nameplate for specific
ratings unique to the model you have
purchased.
6. When pairing with a condensing unit,
ensure the refrigerant pressures for the
paired system do not exceed the
maximum allowable pressures listed on
the unit nameplate.
7. READ THE ENTIRE INSTALLATION,
OPERATION AND MAINTENANCE
MANUAL.
OTHER IMPORTANT
SAFETY PRECAUTIONS ARE
PROVIDED THROUGHOUT THIS
MANUAL.
8.
Keep this manual and all literature
safeguarded near or on the unit.
Units with VFD driven
motors/compressors have adjustable
overload settings. These are set by
the AAON factory for the protection of
these motors/compressors and must
not be adjusted over this factory
setpoint or bypassed.
WARNING