A-PLUS AUTOMATION T2 Series, Инструкция по эксплуатации, Страница: 30 / 48

30
T2300-T2350-T2400-T2450 Double Mitre Saw
5. FUNCTIONING
5.1 USERS
The machine has been projected to be used by only one operator.
The staff assigned to operate with the machine, must be in possession (or acquire through an adequate training)
the requirements indicated here below, and, in addition, to have the knowledge of this handbook and of every
information concerning safety:
• General and technical culture sufficient to comprehend this handbook contents and understand properly
drawings and schemes
• Knowledge of main sanitary, technological and anti-accidental norms
• Overall knowledge of line and plant where is inserted the machine
• Specific experience in cut working technologies
• To know how operate in case of emergency, where to find the individual protection means and how to use them
properly.
The Maintenance Men/Service Engineer, in addition to the above mentioned characteristics, must be in possession
of an adequate technical education.
5.2 CONTROL PANEL
The machine operating control buttons are (see picture 5.2.A):
A = Run control (green button at user’s left)
STOP control (Red button at user’s right)
White Pilot Light
B = Main Switch (position 1=machine fed; position 0=machine not fed)
C = Emergency Control
The Run/Stop controls are located frontally below the working bench; the “B” Main Switch is located on machine’s
right side. Onto the working bench, on the right is placed the red “C” emergency button. The emergency control
button operates if pressed impulsively. The restoration is effected by turning it about 30° clockwise.
Picture 5.2 A = Location of controls
A
B
C
0
OFF
I
ON