A-PLUS AUTOMATION T2 Series, Инструкция по эксплуатации, Страница: 21 / 48

21
Double Mitre Saw T2300-T2350-T2400 - T2450
4.8 ADJUSTMENTS
Being the machine tested in manufacturer premises, the user must only execute the following adjustments:
4.8.1 ADJUSTMENT OF BLADES DESCENT SPEED
The user can adjust, according to the material to be cut,
the blades descent speed. To operate this adjustment,
use the flow governor placed on machine’s left side
(see picture 4.8)
• Turn it clockwise to reduce the blades descent speed
• Turn it counter-clockwise to increase the blades
descent speed.
Picture 4.8
4.8.2 FRONTAL GUARD ADJUSTMENT
Operate as follows for adjusting the height of frontal guard:
• Loosen the “B” knobs (see picture 4.8.1)
• Lift or lower the guard according to the size of the moulding to be worked
• Tighten the knobs
Once finished the working, lower completely the frontal guard.
Picture 4.8.1
To execute the 1
st
starting it is necessary to operate as follows:
• Press the “C” green button (see at picture 4.8.2) located at top right side of the machine to start the motors
running
• Press simultaneously the two “A” push buttons (see picture 4.7.3) to lower the blades
When the motors are running it is necessary:
• Check that right blade rotation sense is counter-clockwise
• Check that the left blade rotation sense is clockwise
It is strongly imprudent to make a cutting test before checking the blades rotation sense.
In case of reverse rotation, the operator risks the projection of material on his face and body.
B