A-PLUS AUTOMATION T2 Series, Инструкция по эксплуатации, Страница: 23 / 48

23
Double Mitre Saw T2300-T2350-T2400 - T2450
• Loosen the handle (see picture 4.8.3 part. B) of every single clamping cylinder positioning it in the desired spot.
• Tighten the handles (picture 4.8.3 part. B) to fasten the chosen positions
B
A
Picture 4.8.3
• Press the foot pedal (picture 4.8.4) to activate the decent of vertical clamps.
Picture 4.8.4
4.8.4 CUTTING STOPS ADJUSTMENT
The machine is equipped with a gauging scale, over which is leaned the moulding to be cut, showing the right
gauging of the moulding length.
To get quicker and more accurate the mouldings length are supplied two stops:
• Fixed stop A (see picture 4.8.5), normally used to measure the “long” side of a frame or to execute with accuracy
cuts of the same length in a repeating way
• Swing stop B (see picture 4.8.5), normally used to obtain the “short” side of a rectangular frame.
•
• Operate as follows to adjust the stops:
• Loosen the “C” knobs (see picture 4.8.5)
• Shift the “A” stop until reaching the desired distance
The distances are considered from the point of the straight blade cuts