A-PLUS AUTOMATION T2 Series, Инструкция по эксплуатации, Страница: 11 / 48

11
Double Mitre Saw T2300-T2350-T2400 - T2450
A: Working Area- B: Dangerous Zones
Picture 3.4.A - Working area and dangerous zones
3.5 PROTECTION DEVICES
The machine is equipped with adequate protections for persons exposed to the risks due to the of mobile elements
of transmission (blades, pulleys, belts, etc.…), or mobile members taking part in working (blades) or ejection of
wooden pieces, chips, or dust.
3.6 STOP FUNCTIONS
The machine stop functions are the following:
• General Switch (category 0)
• Normal Stop Button (category 1)
• Emergency Button (category 1)
STOP CATEGORY 0
Is obtained taking out power from Machine actuators (uncontrolled stop)
STOP CATEGORY 1
Controlled stop with opening of power supplying for the machine actuators after of such a period allowing the
stop of them.
3.7 SAFE WORKING PROCEDURES
The machine is projected and realised with the purpose of eliminating any risk connected with its use.
Owing to the necessity of steering the moulding around blades working area, it is impossible to eliminate the risks
related with possible accidental contacts of operator hands with a.m. area.
The other risks related with manual working mode, are:
• Cut (due to the contact of the operator hands with the blades)
• Entanglement (due to clothes not properly tight)
• Ejection of worked material chips
To drop down to the minimum the consequences of above mentioned dangers, it is necessary to follow carefully
the following instructions:
• when the hands are working closely to the blades, you have to steer the moulding to be cut using any tool
• avoid the cutting of moulding pieces smaller than 50 mm
• never use hands to take out the short pieces and/or cuttings close to the blades, but instead use a tool, i.e. a
piece of moulding still to be cut
• adjust the frontal protection according to the height of cutting pieces and clamp in position
Operate as follows for adjusting the A protection guard of picture 3.7
• unscrew the B knob of picture 3.7
• lift or lower the A guard according to the height of mouldings to be cut
• tighten the guard in the proper position by screwing the B knob (picture 3.7)