A-PLUS AUTOMATION T2 Series, Инструкция по эксплуатации, Страница: 25 / 48

25
Double Mitre Saw T2300-T2350-T2400 - T2450
4.8.5 SETTING OF THE BLADES
4.8.5.1 CONTROL OF THE VERTICAL ANGLE OF THE BLADES
To adjust the vertical angle of the blades, proceed as follows:
1. Open the access cover to the blades and place
a dial gauge against the side of the blade so
that the upper and lower parts can be checked
(ensure that at least 200 mm of vertical travel is
clear to enable a reading to be made)
2. Turn the dial face of the comparator so that the
needle is placed on the “0”;
3. Lower the blade,
4. Check to see that during the scroll the dial does
not deviate from the initial value “0”;
5. Slacken with a size 6 Allen key the top two
screws (A)
6. Turn the two screws (B) to adjust the vertical
angle of the blade:
a) To increase the angle, tighten the screws (max.
1/8 turn).
b) To reduce the angle slightly loosen the screws
(max. 1/8 turn)
7. Tighten the two top screws that were previously
slackened
8. Control the vertical angle (using the dial gauge).
Repeat the operation from point 1 to point 4 until the desired position is obtained
The recommended values are 0 mm at the top and –0.01 mm (maximum –0.03) at the bottom,
4.8.5.2 POSITIONING THE AXIS OF THE BLADES
1. Using a 13 mm spanner, loosen the four screws of
the hub flange (C). This will make it possible to carry
out the setting through the screws “D” and “E”.
2. With a 10 mm spanner loosen the lock nut (D)
3. Act on the adjusting screw (E) to advance the blade
shaft until the distance at the summit between the
two blades is 1.5 - 2.0 mm.