A.O. Smith SGS - 100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 53 / 121

Installation
50 Instruction manual SGS
3
is
SGS 80 to 120
16. If the measure value is within the range given in the table of CO
2
values:
- If you have increased
Tset
, set it back to the original value using .
- Continue with the CO
2
measurement under partial load.
17. If the measured value is not within the range of CO
2
values from the table,
then you may not start the appliance up:
-
Switch off the appliance.
- Turn off the gas supply to the appliance.
- Put the covers back on the appliance.
18. Contact the appliance's supplier.
Partial load measurement
19. From the service menu, select:
-
SERVICE OPERATION
|
PARTIAL LOAD
- Confirm with .
The appliance is now in "PARTIAL LOAD" mode and will ignite.
20. The appliance is now running at
PARTIAL LOAD
. Read the value from the
CO
2
meter and wait until this measured value has remained stable for some
time. This may take several minutes.
21. Compare the CO
2
value measured against the value measured under full
load.
Caution
The CO
2
value at partial load must be within ±0.3 vol% of the CO
2
value
measured or adjusted under full load.
22. If necessary, adjust the CO
2
value using the adjuster screw until the value is
within 0.3 vol% of the CO
2
value under full load.
SGS 28 t/m 60 - CO
2
adjustment (partial load)
SERVICE Ê Ê
PARTIAL LOAD 65ÉC
Tset 70ÉC
RUNNING
IMD-1095c R0