A.O. Smith SGS - 100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 26 / 121

Instruction manual SGS 23
is
Working clearances
Note
When installing the water heater, be aware that any leakage from the tank
and/or connections can cause damage to the immediate environment or floors
below the level of the boiler room. If this is the case, the water heater should be
installed above a waste water drain or in a suitable metal leak tray.
The leak tray must have an appropriate waste water drain and must be at least
5 cm deep with a length and width at least 5 cm greater than the diameter of the
water heater.
3.3.5 Storage tank working clearances
For access to the storage tank, it is recommended that the following
clearances are observed:
•
All sides of the storage tank: 50 cm.
• Above the storage tank (space for anode replacement): 100 cm.
Note
When installing the storage tank, be aware that any leakage can cause
damage to the immediate environment or floors below the level of the boiler
room. If this is the case, the water heater should be installed above a waste
water drain or in a suitable metal leak tray.
3.4 Technical
specifications The water heater is supplied without accessories. Check the
dimensions (3.4 "Technical specifications"), gas data (3.4.3 "Gas data") and
other specifications (3.4.2 "General and electrical specifications") of any
accessories you plan to use.
SGS 28 thru 60 SGS 80 thru 120
IMD-0766 R0
A
A
AA
BB
BB
A
A
AA