3M PELTOR WS LiteCom Plus, Руководство пользователя

Страница: 269 / 270

TECHNICAL DATA
POWER
Powered by a rechargeable Li-ion battery pack (ACK081).
3.7 V, 1800 mAh
OPERATING TIME
Expected operating time (according to standardized
measurement) in room temperature with ACK081
*WS
TM
LiteCom Plus: Approximately 18 hours
LiteCom Plus: Approximately 20 hours
EXTERNAL INPUT
3M™ PELTOR™ Type J111-A 4-pole connector for external equipment
RADIO
Frequency range LPD: 433.075-434.775 MHz
PMR: 446.00625-446.19375 MHz,
*Bluetooth
®
: 2402-2480 MHz
Operation mode Half-duplex
Antenna PMR and LPD:
¼ wave, integrated whip antenna
Fixed to the headset
Omni directional
Gain: 0,65 dBi
Bluetooth
®
:
PCB antenna
Gain: 0 dBi
Channels LPD: 69 channels PMR (EU only): 16 channels
Channel raster 12.5 kHz
Channel spacing 12.5 kHz and 25 kHz
Modulation Analogue:
Narrow 2.5 kHz (FM) for PMR versions,
Wide: 5 kHz (FM) for LPD versions.
Receiver sensitivity Typical -120 dBm
Output power Bluetooth
®
(max.) 2.5 mW ERP
Output power LPD (max.) 10 mW ERP duty cycle up to 10%
Output power PMR (max.)
High power: 150 mW ERP
Low power: 25 mW ERP
EXTERNAL INTERFACE PIN OUT
Pin 1 EXTERNAL PTT
Activated when shorted to Pin 2 (ground)
Pin 2 GROUND
Pin 3 INPUT
The input signal is mixed with the WS™ WS LiteCom Plus Headset
audio output level (speaker output).
120.5 mV = Input signal level for which the mean plus one standard
deviation equals 82 dB(A) in cup.
Pin 4 BOOM MICROPHONE OUTPUT
Applied signal at the boom microphone input comes out on pin 4
2.25 mV Microphone input = 30 mV output
* Only WS
TM
(Bluetooth
®
) models