6
78-8140-2401-0-B
4.5
Position and route grounds to minimize
interference with cables ports and splicing.
Cable end ground connections are made after
the cables are installed in the base.
Note: The installation and removal of the ECAM
27MM-D is the same for both the metallic and
the non-metallic versions. For demonstration
purposes, the metallic version will be used
throughout the instruction manual.
5.0 3M
™
Double Cable Assembly ECAM 27MM-D Removal
5.1
Using a 3/8 inch (10 mm) nut driver loosen the
clamp screws on the external cable assembly
module (ECAM). Pull clamps outward and
rotate as shown. Lightly re-tighten screw to
hold clamps in place.
5.2
Loosen the three screws and separate the top and
bottom halves of the 27-mm ECAM double cable
assembly using a 3/8 inch (10 mm) nut driver.
5.3
Loosen the three screws to remove the cable
clamp from the bottom half of the of the 27-mm
ECAM double cable assembly using a 3/8 inch
(10 mm) nut driver. Keep the longer center screw
located in the center position.