![background image](http://html1.mh-extra.com/html/3m/ecam-27mm-act/ecam-27mm-act_instructions-manual_442559014.webp)
14
78-8140-2401-0-B
8.17 Finish tightening the two screws marked 'A' until the gaps between the halves are closed or nearly
closed. Then finish tightening the screw marked 'B'. Torque all three screws to 45 in.-lbs.
Note: Do not exceed 50 in.-lbs. of torque
8.18 Trim excess mastic using snips or knife.
Note: Do not cut flush or pull out rope mastic. Leave
1/8 inch (4mm) of the ends of the rope mastic
protruding.
8.19 Press mastic flat using a finger tip.
9.0 Cable Strength Member Installation; For all loose buffer tube and
dielectric central tube cables
9.1
Remove vinyl caps and cable strength member
(CSM) clamps from the CSM bracket. Position
CSM rod next to bracket and trim to fit as
shown.