12
78-8140-2401-0-B
8.10 Peel the mastic rope from the liner and place into the groove in the 3M
™
Double Cable Entry Port
ECAM-27MM-D bottom half. Press mastic rope in place and route as shown. Make sure at least 0.25
inches (6 mm) of the mastic rope extends out both ends as shown.
8.11 Install the first cable into the external cable
assembly module (ECAM) housing bottom half.
Note the grooves in the housing for locating
washers.
Note: If differently-sized cables are used, ensure the
cable is placed into the correct cable clamp shell
set in bottom housing.
Note: On cables prepared for grounding, install the
cable into the bottom housing with cable sheath
tab facing up as shown.
8.12 Install the second cable into the housing. Note
that the washers are offset from the first set.
Note: Ensure washers are properly seated into their
corresponding grooves in bottom housing.
