14
Adjustments
(Continued)
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury and/or equipment damage.
Converting Lower Head to Upper Head
The AccuGlide
™
II
STD 1-1/2 Inch Lower Taping
Head can be used as an upper head to tape the top
of boxes by making the following modification:
1.
Remove the (black) applying mechanism
spring P/N 78-8070-1273-3 (Figure 4798-10),
and replace it with the (silver) applying
mechanism spring P/N 78-8070-1274-1,
available in spare parts.
2.
Mount the taping head per installation
guidelines on page 5 of this manual.
Note – Tape loading/threading on upper
head will be from the opposite side of
machine.
To Adjust Tension:
1.
Wrap a cord or small strap (non-adhesive) 4-6
turns around the tension roller.
2.
Attach a spring scale to the end of the cord or
strap.
3.
Turn the adjusting nut with the socket wrench
provided, until a force of approximately 0.5 kg to
0.9 kg [1-2 lbs. ] is required to turn the roller by
pulling on the spring scale.
One-Way Tension Roller
Figure 5-7
The one-way tension roller is factory set. When
replacing this assembly, the roller must have
0.5 kg [1 lb.] minimum tangential force when turning.
Figure 5-7 – One-Way Tension Roller
Содержание AccuGlide II 29600
