3M AccuGlide II 29600, Инструкция и перечень запасных частей

Страница: 17 / 36

12
Adjustments
(Continued)
Figure 5-4 – Tape Drum Friction Brake
Figure 5-3 – Tape Web Alignment
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury and/or equipment damage.
Tape Web Alignment – Figure 5-3
The STD tape drum assembly is pre-set to
accommodate 36 mm [1.50 inch] wide tape. The
tape drum assembly is adjustable to provide
alignment of narrower tapes. If adjustment is
necessary to center the tape width on the centerline
of the taping head, (and therefore box center seam),
make adjustment as follows:
1. Loosen the locking hex nut behind tape drum
bracket on tape drum shaft. Use an adjustable
wrench or 25 mm open end wrench.
2. Turn tape drum shaft in or out to center the tape
web (use 5 mm hex wrench).
3. Tighten locking hex nut to secure the
adjustment.
No other components require adjustment for tape
web alignment.
Tape Drum Friction Brake – Figure 5-4
The tape drum friction brake on each taping head is
pre-set for normal operation to prevent tape roll over
travel. Should tension adjustment be required, turn
the self-locking nut on the shaft to vary
compression of the spring. Turn the nut
clockwise to increase the braking force, and
counterclockwise to decrease the braking force.
Adjust brake to minimum tension to prevent
excessive tape roll over travel.
Note – Excess braking force will cause poor
tape application and may lead to tape tabbing
on the trailing tape leg.