3M AccuGlide II 29600, Инструкция и перечень запасных частей

Страница: 12 / 36

7
Operation
(Continued)
1. Turn air and electrical supplies off and disconnect before servicing taping head.
2. Never attempt to work on the taping head or load tape when the box drive system is running.
3. The taping head uses an extremely sharp tape cut-off knife. Before working with the taping
head or attempting to load/thread tape, refer to Figures 3-1 and 3-2 and identify the knife
location. Keep hands out of these areas except as necessary to service the taping head.
4. Failure to comply with these warnings can result in severe personal injury and/or equipment
damage.
It is recommended that the detailed instructions and
sketches in this manual be referred to the first few
times the taping head is loaded/threaded until the
operator becomes thoroughly familiar with the tape
loading operation.
Figure 3-3 – Tape Loading
Figure 3-4 – Tape Loading
WARNINGS
Tape Loading – Lower Taping Head
1. For ease in loading, first remove the lower
taping head from the conveyor bed.
2. Use the plastic threading needle (provided) and
follow the loading procedures (Figures 3-3 to
3-5) to complete the tape threading.
Tape Loading – Upper Taping Head
(AccuGlide™
II
STD 1-1/2 Inch Lower Taping Head
optionally mounted for top taping.)
1. Raise the upper taping head to a convenient
working position.
2. The upper taping head is loaded and threaded in
the same manner as the lower head. Follow the
lower taping head tape loading/threading
procedure.
Figure 3-3
Insert threading needle through rollers in direction
indicated by arrows.
Figure 3-4
Place tape roll on tape drum to dispense tape with
adhesive side forward. Seat tape roll fully against
back flange of drum. Adhere tape lead end to
threading needle as shown.