3M AccuGlide II 29600, Инструкция и перечень запасных частей

Страница: 16 / 36

11
Adjustments
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury and/or equipment damage.
Figure 5-1 – Applying Mechanism Spring
Applying Mechanism/Buffing Extension Springs
To obtain access to the spring, remove the taping
head cover (four mounting screws). Replace cover
when finished.
Boxes must be properly filled to support the flaps for
the buffing roller pressure. Buffing roller pressure is
adjusted with the applying mechanism and buffing
extension springs.
APPLYING MECHANISM SPRING
The applying mechanism spring, shown in
Figures 3-1, 3-2 and 5-1 controls applying and
buffing roller pressure on the box and returns the
mechanism to the reset position. The spring
pressure is pre-set at the factory, as shown in
Figure 5-1A for normal operation.
If a tape gap appears on the trailing surface of the
box, increase spring pressure. If the front or rear of
the box is being crushed by the applying roller,
decrease the spring pressure or remove buffing
extension spring from buffing arm assembly. See
"Buffing Extension Spring", below.
Removing the spring end loop from the spring holder
and placing in other holes provided, as shown in
Figure 5-1B, will adjust the spring pressure. Spring
pressure should be set to the minimum possible
while maintaining good tape application.
BUFFING EXTENSION SPRING
If buffing roller force cannot be reduced enough by
adjusting the applying mechanism spring, the buffing
extension spring shown in Figure 3-1, 3-2 and 5-2
can be removed to reduce pressure. In this case,
the applying mechanism spring will have to be re-
adjusted to provide sufficient buffing roller pressure
to adequately buff the tape seal.
Figure 5-2 – Buffing Extension Spring