13
Adjustments
(Continued)
|
Figure 5-5 – Leading Tape Leg Length
Figure 5-6 – Changing Tape Leg Length
Tape Leg Length
1.
Remove and retain two hex head screws and
remove the brush from normal position “A” on
side frame.
2.
Remount and secure brush in position “A-A” on
side frame forward of normal location using
original fasteners.
3.
Remove cut-off bracket extensions from position
"B".
4.
Remount cut-off bracket extensions in forward
position “B-B”.
5.
Remove and retain the one-way tension roller
assembly from slot “C” in frame.
6.
Remount tension roller assembly near top of slot
“C-C” in frame using original fasteners.
7.
Adjust tension roller according to "Leading Tape
Leg Length Adjustment" above.
LEADING TAPE LEG LENGTH ADJUSTMENT –
Figure 5-5
The one-way tension roller position is adjustable to
control the leading tape leg length.
Moving this roller farther away from the box top or
bottom surface will decrease the leading leg length.
Moving it closer to the box top or bottom surface will
increase the leading leg length.
WARNING – Turn air and electrical
supplies off and disconnect before
beginning adjustments. Failure to comply
with this warning could result in severe
personal injury and/or equipment damage.
WARNING – Use care when working
near cut-off knife as knife is
extremely sharp. If care is not taken,
severe injury could result.
CHANGING TAPE LEG LENGTH FROM
50 to 70 mm [2 to 2.75 INCH] – Figure 5-6
Note – When changing tape leg length, both
upper and lower heads must be adjusted to
apply the same leg lengths.
Содержание AccuGlide II 29600
