3e Technologies International AirGuard 3e-525C-2, Руководство пользователя

Страница: 73 / 80

3e–525C–2 Wireless Access Point Chapter 4: Wireless Bridge Configuration
64 29000155-001 A
3e–525C–2 Wireless Access Point Chapter 4: Wireless Bridge Configuration
29000155-001 A 65
Point-to-Multipoint Bridging Setup Guide - Manual Mode
Direction Bridge 1 Bridge 2 ~ n
Wireless Bridge — General (Manual Bridging Mode)
Wirelss Mode
802.11a 802.11a
Tx Rate
AUTO AUTO
Channel No. Same as Bridge 2~n Same as Bridge 1
Tx Power
Auto Auto
Propagation Distance
< 5 Miles < 5 Miles
Bridging Mode
manual bridging se-
lected
manual bridging selected
Signal Strength LED MAC Not Assigned (select
from drop-down list)
Not Assigned (select from
drop-down list)
Spanning Tree Protocol Enable (or Disable if no
bridging loop possible)
Enable (or Disable if no
bridging loop possible)
BSSID Add Bridge 2~n MAC Add Bridge 1 MAC
Wireless Bridge — Encryption
Bridging encryption options
Select appropriate key
type/length and value.
Must be the same key
as Bridge 2~n.
Select appropriate key
type/length and value.
Must be the same key as
Bridge 1.
Point-to-Multipoint Bridging Setup Guide - Auto Mode
Direction Bridge 1 Bridge 2 ~ n
Wireless Bridge — General (Auto Bridging Mode)
Wirelss Mode
802.11a 802.11a
Tx Rate AUTO AUTO
Channel No. Same as Bridge 2~n Same as Bridge 2~n
Tx Power Mode Auto Auto
Propagation Distance
< 5 Miles < 5 Miles
Bridging Mode
Auto bridging selected Auto bridging selected
SSID
Must be the same as
Bridge 2~n
Must be the same as Bridge 2
Max Auto Bridges 40 (range 1-40) 40 (range 1-40)
Bridge Priority 40 (range 1-40) 40 (range 1-40)
Signal Strength MAC Enter from list at the
bottom of the screen
Enter from list at the bottom
of the screen
Wireless Bridge — Encryption
Bridging encryption options
Select appropriate
key type/length and
value. Must be same
as Bridge 2.
Select appropriate key type/
length and value. Must be
same as Bridge 2.
Wireless Bridge — MAC Address Filtering
MAC Address Filtering options
Select Filter Type: in-
put MAC addresses
Select Filter Type: input
MAC addresses
The above recommended setup requires only Bridge 1 to be set in
point-to-multipoint mode. It is possible to set all bridges in point-to-
multipoint mode, in which case , each bridge would have to contain the
BSSID for each of the other bridges and Spanning Tree Protocol must be
Enabled.