3DCPI 3DCPI-02, Руководство для стартапов

Страница: 43 / 44

3DCPI-02
START-UP GUIDE
smooth operation of the machine, it needs cleaning regularly. To clean it, unscrew the
two bolts at the lower corners of the fan. Pull out the motor assembly behind the fan and
use a knife to remove all the pieces of filament stuck to the drive gear. Then, reseat the
motor assembly and screw the two bolts.
Cleaning the build platform
The build platform can be removed from CubeII. Take out the build platform with the
object (if it isn’t large). When the nozzle is too close to the build platform, it’s hard to
release the object from the build platform. Use a shovel to pry the corners of the object
and then you’ll be able to peel it away. After cleaning, reseat and level the build
platform.
Abnormal noise on X and Y axes
Exchange the wires of X-axis motor and Y-axis motor on the board. Open ReplicatorG
and go to the Control Panel to move X and Y axes. Reseat the wires of X and Y axes
and check if the problem is fixed. If there’s still abnormal noise, please contact us for
technical support.
Warping when building
Observe the warping position of the object, and adjust the screws beneath the build plate.
Raise the side of the build plate right below the warping. Suggest printing in a confined
space, reducing air flow. Moreover, check whether the distances between the four
corners of the build plate and the nozzle are equal. Follow “The first layer doesn’t stick
to the build plate” section to adjust.
Fixing the loose X-axis belt