3D Systems Viper Pro SLA iPro 8000, Быстрый старт, Страница: 26 / 81

q u i c k s t a r t g u i d e r d m i n s t a l l a t i o n a n d r e m o v a l
26
1 Open the front machine door that corresponds to the resin’s build zone until the vent hold, on
the topmost end of the bottle, is visible.
2 Place the vent cap on the vent hole and screw tightly to prevent the resin from spilling.
3 Pull the RDM lever, located to the left of the resin bin, (Figure 5., “Release Lever,” on page
24) toward you.
4 When the resin has properly drained, release the inner latch and lift until the resin container is
visible.
5 Push the container release button, (Figure 6., “Container Release Button,” on page 25) located
on the lower right corner of the resin bin.
6 Lift out the resin container.
7 Using a disposable paper towel, wipe all resin from the container seal assembly.
8 To remove the container, carefully lift it from the container slot, place the vent cap back on,
dispose of the container according to local regulations.