3D Systems DMP Flex 350, Оригинальное руководство пользователя

Страница: 38 / 45

3D Systems, Inc. 34 p/n: 15-D99, rev. C
8 LIFTING EQUIPMENT
8.1 Inspect Exterior of Printer Crates
If the DMP Flex 350 arrives before the 3D Systems CSE:
• Visually inspect the exterior of the crates for any damage that may have occurred during transport.
• Notify 3D Systems Service immediately if anything is evident at this point. DO NOT proceed with the installation until
you have discussed the damage with 3D systems.
If damage is discovered, leave the item in its original container and packaging and request immediate inspection from the
carrier within 15 days from delivery date. If the crates are not damaged, they are ready to be lifted into the facility and be
uncrated by a 3D Systems CSE or an authorized reseller.
After inspecting the crates, the lifting of the equipment can be done. All damage after moving the crates
is considered by moving the equipment. 3D Systems is not responsible for any damage after delivering the
crates.
PLEASE CONTACT A CERTIFIED LIFTING COMPANY TO MOVE THE CRATES AND/OR EQUIPMENT.
8.2 Before Moving the Equipment
WARNING: BEFORE YOU MOVE THE EQUIPMENT VERIFY THE FOLLOWING:
• CRATE DIMENSIONS AND WEIGHTS ARE LISTED IN CHAPTER 4: EQUIPMENT AND PACKAGING.
• MAKE SURE THE RATED CAPACITY OF THE LIFTING EQUIPMENT YOU PLAN TO USE WILL ACCOMMODATE THE
CRATED AND UNCRATED WEIGHT OF THE DMP FLEX 350 PRINTER AND THE DMP FLEX 350 PMU.
• IF A FORKLIFT IS USED, THE FORKS SHOULD BE AT LEAST 2000 MM (80 INCHES) LONG TO REACH THE LOWER
LIFTING SUPPORTS.
• MAKE SURE ALL LIFTING EQUIPMENT WILL FIT THROUGH ALL DOORWAYS LEADING TO THE INSTALLATION
ROOM. CHECK BOTH HEIGHT AND WIDTH.
WARNING: LIFTING/MOVING THE PRINTER MAY AFFECT CERTAIN COMPONENTS AND SETTINGS (ALIGNMENTS,
CALIBRATION, ...). PLEASE CONTACT YOUR CERTIFIED SERVICE TRAINED 3D SYSTEMS REPRESENTATIVE TO
SCHEDULE AN ON-SITE INTERVENTION TO CHECK THE PRINTER OPERATION AFTER MOVING