3Com OfficeConnect WX1200, Справочник по командам

Страница: 333 / 646

set {ap | dap} name 333
If you use the name none , spelled in any combination of capital or
lowercase letters, the specified MAP access point is cleared from all MAP
access point groups.
Examples — The following command configures a MAP access point
group named loadbalance1 that contains the MAP access points on ports
1, 3, and 5:
WX1200# set ap 1,3,5 group loadbalance1
success: change accepted.
The following command removes the MAP access point on port 4 from all
MAP access point groups:
WX1200# set ap 4 group none
success: change accepted.
See Also
„
display {ap | dap} config on page 290
„
display {ap | dap} group on page 303
set {ap | dap} name
Changes a MAP name.
Syntax —
set { ap port-list | dap dap-num } name name
„
ap port-list — List of ports connected to the MAP access point to
rename.
„
dap dap-num
— Number of a Distributed MAP to rename.
„
name
— Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is
MAP01 . The default
name of a Distributed MAP is based on the number you assign to it when
you configure the connection. For example, the default name for
Distributed MAP 1 is
DAP01 .
Access — Enabled.
History —Introduced in MSS Version 3.0. Default Distributed MAP name
changed from DMP num to DAP num in MSS Version 4.1.