3Com OfficeConnect WX1200, Справочник по командам

Страница: 309 / 646

display auto-tune attributes 309
display auto-tune
attributes
Displays the current values of the RF attributes RF Auto-Tuning uses to
decide whether to change channel or power settings.
Syntax —
display auto-tune attributes
[ ap map-num [ radio { 1 | 2 | all }]]
Syntax —
display auto-tune attributes
[ dap dap-num [ radio { 1 | 2 | all }]]
„
map-num
— MAP port connected to the MAP access point for which to
display RF attributes.
„
dap-num — Number of a Distributed MAP for which to display RF
attributes.
„
radio 1 — Shows RF attribute information for radio 1.
„
radio 2
— Shows RF attribute information for radio 2. (This option
does not apply to single-radio models.)
„
radio all
— Shows RF attribute information for both radios.
Defaults — None.
Table 57 Output for display ap status terse and display dap status terse
Field Description
Port WX port number connected to the MAP.
Flg Operational status flags for the MAP.
For flag definitions, see the key in the command output.
IP Address IP address of the MAP. The address is assigned to the MAP by
a DHCP server.
This field is applicable only if the MAP is configured on the
WX switch as a Distributed MAP.
Model MAP model number.
MAC Address MAC address of the MAP.
Radio1 State, channel, and power information for radio 1:
The state can be D (disabled) or E (enabled).
The channel and power settings are shown as
channel / power .
Radio2 State, channel, and power information for radio 2.
Uptime Amount of time since the MAP booted using this link.